Building Product Brochures & Datasheets

Conductive Floor Covering

Transit Floor Covering Laying Instructions

Floor Covering Laying Instructions The best possible tiles will not give satisfactory service without careful preparation of the underlying floor and the correct type of adhesive. It is vital that the floor should be clean, dry and level, without trace of dust, wax, grease, oil, solvents etc. Sheets of plywood or hardboard, at least 4mm thick, can be used to cover wooden floors prior to the laying of the tiles. Boards should be fixed with screws, counter sunk or serrated nails at approximately 150mm intervals over the face and approximately 100mm intervals along the edges. Moisture content of screed must not exceed 3%. This should be checked prior to installation. If in doubt consult adhesive manufacturers.

Transit Floor Covering | Laying Instructions for Transit Conductive Floor Tiles

Laying Instructions Conductive Floor The best possible tiles will not give satisfactory service without careful preparation of the underlying floor and the correct type of adhesive. It is vital that the floor should be clean, dry and level, without a trace of dust, wax, grease, oil, solvents etc.

X-Tech AntiStatic SLE applied to new concrete using X-Shield SF Primer or MT Primer

Method Statement on how to apply TAL X-Tech AntiStatic SLE to new concrete using X-Shield SF Primer or MT Primer.

X-Tech AntiStatic SLE Conductive epoxy flooring system

TAL – X-Tech AntiStatic SLE is a three layer system comprising an epoxy primer, a water dispersed epoxy base coat and a self smoothing epoxy top coat that produces a conductive or dissipative floor. The conductive grade (CG) provides a floor with a point to point resistance and a resistance to ground of between 5 x 104 to 1 x 106 Ohms. The dissipative grade (DG) provides a floor with a point to point resistance and a resistance to ground of between 5 x 106 to 1 x 109 Ohms.

X-Tech AntiStatic SLB applied to new concrete using X-Shield WD Primer

Method Statement on how to apply TAL- X-Tech  AntiStatic SLB to new concrete using X-Shield WD Primer.

X-Tech AntiStatic SLB

X-Tech AntiStatic SLB is a three layer breathable system comprising a water dispersed primer, a water dispersed epoxy base coat and a water based self smoothing epoxy top coat that produces a conductive or dissipative floor. When used with X-Tech Conductive Base Coat the floor will have a point to point resistance and a resistance to ground of between 5 x 104 to 1 x 106 Ohms. When used with X-Tech Dissipative Base Coat the floor will have a point to point resistance and a resistance to ground of between 5 x 106 to 1 x 109 Ohms.


Copyright © 2020 New Media, a division of Media24. All rights reserved.