Building Product Brochures & Datasheets

Primer

abe.®cote 337 | Tough epoxy paint

Tough Epoxy Paint abe.®cote 337 is a two component, solvent free, water-dispersed, polyamide cured epoxy.

abe.®proof liquid membrane primer

abe.®proof liquid membrane primer is a single pack, solvent borne, liquid primer applied to most building substrates, this would include: abe.®proof liquid membrane primer can be used to prime most building substrates typically: • Porous surfaces, deficient bituminous surfaces, wood as well as sound concrete and non-porous screeds • A surface conditioner to obtain optimum performance from the products applied as top coats

Uniloc Range of Products

Union Tiles – Uniloc product catalogue

PrimerCote Tough adhesive for new screeds

PrimerCote is a tough adhesive for new screeds, No dilution required, needs to be mixed with Cemcrete’s FlexBond, Will ensure screed adheres to substrate

Superprime

A blue, modified one-part moisture-curing polyurethane primer specially designed for difficult and dense surfaces, such as fibreglass, before tiling onto these surfaces. Also suitable for priming the backs of mesh-reinforced or resin-backed tiles, as cementitious adhesives are not compatible with these products.

Bitumen Primer | Technical Datasheet

Bitumen Primer is a hydrocarbon solvent based bituminous primer coat for sealing and preparation of surfaces for the application of bitumen waterproofing products.

abe® VIP Germany | Coating Field Joint Seals for Conoco Phillips - Weybridge

The customer Conoco-Phillips from Weybridge in Surrey wanted to protect the field joint connectors made from steel and GRP plastic with a tough, water-vapour-tight, sea water proof and highly abrasion resistant coating. VIP advised the use of QuickSpray Industrial to their approved applicator PPC from Keighley. After shotblasting the steel, the connectors were masked off. Then the steel surface was cleaned, afterwards primed with the QuickPrime 1K universal PU primer for superior bond to the substrate and than coated using a Gaco Reaktor HX-P2 hotspray machine. A film thickness of at least 3mm throughout was achieved easily and after just 1 hour the connectors were prepared for shipping on site.


Copyright © 2019 New Media, a division of Media24. All rights reserved.